High Performance 6-Axis MEMS MotionTracking™ Device

MFG Part #:


Part #:
Lead Time 26 weeks
RoHS Status:
Unit Price:$1.38
Minumum Qty: 5000
Need a lower quantity?
Ask a Question
Call Me
Email This Page

Product Information

Back to top
The ICM-20600 is a 6-axis MotionTracking device that combines a 3-axis gyroscope, 3-axis accelerometer, in a small 2.5 x 3 x 0.91mm (14-pin LGA) package.

• High performance specs
- Gyroscope sensitivity error: ±1%
- Gyroscope noise: ±4mdps/√Hz
- Accelerometer noise: 100µg/√Hz
• Includes 1K-byte FIFO to reduce traffic on the serial bus interface, and reduce power consumption by allowing the system processor to burst read sensor data and then go into a low-power mode
• EIS FSYNC support

ICM-20600 includes on-chip 16-bit ADCs, programmable digital filters, an embedded temperature sensor, and programmable interrupts. The device features an operating voltage range down to 1.71V. Communication ports include I²C and high speed SPI at 10MHz.

• Smartphones and Tablets
• Wearable Sensors
• IoT Applications
• Motion-based game controllers
• 3D remote controls for Internet connected DTVs and set top boxes, 3D mice

Symmetry Electronics is an authorized InvenSense distributor.


Back to top
3-Axis Gyroscope with Programmable FSR of 250dps, 500dps, 1000dps,and 2000dps
3-Axis Accelerometer with Programmable FSR of 2g, 4g, 8g,and 16g
User-programmable interrupts
Wake-on-motion interrupt for low power operation of applications processor
1 KBFIFO buffer enables the applications processor to read the data in bursts
On-Chip 16-bit ADCsand Programmable Filters
Host interface: 10MHz SPIor 400kHz Fast Mode IC
Digital-output temperature sensor
VDD operating range of 1.71 to 3.45V
MEMS structure hermetically sealed and bonded at wafer level
RoHS and Green compliant


Back to top
InvenSense Datasheet

Previously Viewed Products