Evaluation Board for IC-HT

Manufacturer:
MFG Part #:

IC-HT EVAL HT1D

Part #:
IC-HTEVALHT1D
Availability:
Short Lead Time
RoHS Status:
Unit Price:$123.25
Qty:
Minumum Qty: 1
Ask a Question
Call Me
Email This Page
 
 

Product Information

Back to top

iC-Haus Eval Board for IC-HT Laser Diode Driver

Dual CW laser diode driver iC-HT can operate two individual laser diodes with up to 750 mA laser current depending on the heat dissipation.  Each channel can be enabled independently.  The laser diode driver can be controlled by an external microcontroller (MCU mode) or operate stand alone with pin/resistor configuration (iC-WK mode).  In MCU mode, both channels can be combined for driving up to 1500 mA.

Each channel can be opperated individually either in automatic current control (ACC) or automatic power control (APC).  All parameters including the internal reference voltages are set via serial communication.  A 10 bit resolution D/A converter with logarrithmic characteristics is used for setting the opperating point.  This allows an operating point resolution better than 1%.

 

 

 

Features

Back to top
iC-Haus iC-HT Features:
Up to 1500mA with both channels combined
2.8V to 8V power supply
Operation with or without Controller
Individual enable input per channel
Control loop accuracy better than 1%
Internal programmable logarithmic monitor resistor
Operating point setup with 10 bit logarithmic resolution
ACC or APC mode individually configuable for each channel
A/D converters for analog monitoring
Serial programming interface (SPI or IC compliant)
Configuation content verification and validation
Laser channel disable with programmable over current threshold
Optimized for N-type laser diodes
Low drop linear regulator for3.3V
Low current stand by mode
Temperature monitor
Temperature range -40...85C
Dual channel CW operation with up to 750mA per channel
 

Previously Viewed Products

Evaluation Board for IC-HT
Part #: IC-HT EVAL HT1D
Evaluation Board for IC-HT