Bidirectional µP Interface to 24V

MFG Part #:


Part #:
In Stock
RoHS Status:
This item is currently not available for purchase online.

Please call us at 877-466-9722 to request a quote.
Ask a Question
Call Me
Email This Page

Product Information

Back to top
iC-VRV is an 8-fold low-side driver with integrated control logic which is divided internally into two mutually independent blocks (nibbles).

In the input mode, ports IO0 to IO7 can be used to record logical levels. In this process, a programmable pull-down current (200 μA or 2 mA) sets a defined level and functions as the biasing current for switching contacts. The stages programmed as outputs can drive any desired loads (e. g. lamps, long cables, relays) at a continuous current of 100 mA or 500 mA in pulse operation. The free-wheeling currents created upon each stage turn-off are discharged through the integrated free-wheeling diodes to a voltage applied externally to the COM pin; a circuit with a Zener diode is also possible.

In the event of a short circuit, a protective circuit breaker ensures that the output stage affected does not just simply switch off but is instead clocked as a function of the load. As a result, the current assumes a low average value. The output stage is ready for operation immediately just as soon as the cause of the short circuit has been eliminated.

The shutdown at overtemperature protects the IC against thermal destruction by causing the output stages to turn off and the pull-down currents to be reduced from 2 mA to 200 μA. This shutdown is also triggered in case of undervoltage at VCC.

Due to the microprocessor interface the iC-VRV can be operated directly on a bus system. The interface consists of the data bits D0 to D7 and the associated control signals A0, A1, CSN, WRN and RDN. The signal CLK clocks the implemented digital input filter and BLFQ clocks the programmed flashing function. In the event of a signal change of the I/O pins programmed as inputs, an interrupt signal can be generated at output INTN.

Activating the input RESN resets the initial condition.

Chip programming is conducted via four addresses at A0 and A1. During this programming, presettings for flashing frequencies, filtering times, interrupt control, pull-down currents and input/output mode, etc. are stored in two registers (CONTROL WORD1+2).

All inputs and outputs are protected with diodes against destruction due to ESD.

iC-Haus iC_VRV_001


• Dual quad low-side driver as bidirectional μP interface with digital filtering in 24 V industrial applications

Symmetry Electronics (and its e-commerce division: is an authorized iC-Haus distributor.


Back to top
2 4 bidirectional input/output stages at 24 V
Input/output mode programmable for each 4 bits
Guaranteed low-side driving capability of 100 mAdc and 500 mApeak for pulse load
Short-circuit-proof driver with high electric strength up to 48 V
Low saturation voltage of 0.4 V at 10 mA and 1.5 V at 500 mA
Programmable pull-down current sources
Built-in free-wheeling diodes with externally accessible common cathode
Flashing function for the outputs
Programmable digital input filters with externally adjusted filtering times
Bus capability via high-speed microprocessor interface
Programmable interrupt output
Shutdown at overtemperature and low voltage

Previously Viewed Products

Bidirectional µP Interface to 24V