Linear Hall Sensor PWM 3 Wire TO92UT

Manufacturer:
MFG Part #:

HAL2850UT-A-2-B-1-00

Part #:
HAL2850UT-A
Family:
Availability:
In Stock
End Of Life:
9/30/2020
Unit Price:$1.393
Qty:
Minumum Qty: 1
Ask a Question
Call Me
Email This Page
 
 

Product Information

Back to top
The HAL 2850 is a new member of the -Micronas varioHAL (HAL 28xy) family of programmable linear Hall-effect sensors. 
    
    
It features a digital PWM output with slew-rate control, that enables a fast and robust data transfer in harsh environments. The PWM signal can be directly decoded by any unit measuring a duty cycle of a rectangular signal (usually a timer/capture unit in a microcontroller).
The highest available PWM frequency is 2 kHz with 12-bit resolution. The PWM frequency is customer-programmable in a range between 30 Hz and 2 kHz, with a certain resolution. The open-drain output with programmable slew rates enables an excellent EMI performance of the total system.
  
The HAL 2850 features a Hall-plate with spinning current offset compensation technique and a precise temperature sensor which is used for temperature compensation of both the Hall-sensors sensitivity and offset.
  
The sensor provides digital signal processing. This is of great benefit because analog offsets, temperature shifts, and mechanical stress do not degrade digital signals. 
  
Major characteristics, such as magnetic field range, sensitivity, offset, output polarity, clamping levels, PWM frequency, and the temperature coefficients of sensitivity and offset, can easily be adjusted to the magnetic circuit by programming the non-volatile memory.
The HAL 2850 is available in the very small leaded package TO-92UT.
     
System Architecture
The HAL 2850 sensors are produced in a proven automotive submicron CMOS technology.
The HAL 2850 features a temperature-compensated Hall plate with spinning-current offset compensation, an A/D converter for the Hall-plate, an A/D converter for the temperature sensor, digital signal processing (RISC processor), a digital PWM interface, an EEPROM memory with redundancy and lock function for the calibration data and the PWM output configuration, and protection devices on all pins.
The HAL 2850 is programmable by means of BiPhase-M telegrams. No additional programming pin is needed. The sensor is programmed through its output pin.
Major Applications
Due to the sensor’s versatile programming characteristics and low drifts, the HAL 2850 is the optimal system solution for applications such as:
Contactless potentiometers
Angular measurements (e.g. valve, pedal position)Linear movement (e.g. seat track position)Linear force or torque measurements
Current sensing (e.g. battery management)Leveling (e.g. fuel level, suspension control or headlight leveling)
 

Features

Back to top
High-precision linear Hall-effect sensor
Spinning-current offset compensation
Built-in temperature sensor
On-board diagnostics (over temperature, over current, etc.)
Customer-programmable temperature compensation of output sensitivity (2nd order) and output offset (1st order)
Operating junction temperature range: −40 (degrees)C170 (degrees)C.
Magnetic characteristics are extremely robust against mechanical stress.
Digital signal processing
12-bit resolution
Sampling rate up to 2 kHz with internal low-pass filter
Sample accurate transmission (each PWM period transmits a new Hall sample)
Programmable PWM frequency in a range between 30 Hz and 2 kHz
Non-volatile EEPROM with redundancy and lock function
Open-drain output with slew-rate control
Individual serial number for each sensor
12-bit customer serial number
 

Documents

Back to top

Previously Viewed Products

Linear Hall Sensor PWM 3 Wire TO92UT
Part #: HAL2850UT-A-2-B-1-00
Linear Hall Sensor PWM 3 Wire TO92UT