Hall Switch Differential High Sensitivity SOT89

Manufacturer:
MFG Part #:

HAL300SF-A-4-R-1-00

Part #:
HAL300SF-A
Family:
Availability:
Short Lead Time
RoHS Status:
End Of Life:
7/31/2017
 
This item is currently not available for purchase online.

Please call us at 877-466-9722 to request a quote.

Ask a Question
Call Me
Email This Page
 
 

Product Information

The HAL® 300 is a differential Hall switch produced in CMOS technology. The sensor includes 2 temperaturecompensated Hall plates (2.05 mm apart) with active offset compensation, a differential amplifier with a Schmitt trigger, and an open-drain output transistor. The HAL 300 is a differential sensor which responds to spatial differences of the magnetic field. The Hall voltages at the two Hall plates, S1 and S2, are amplified with a differential amplifier. The differential signal is compared with the actual switching level of the internal Schmitt trigger. Accordingly, the output transistor is switched on or off. The sensor has a bipolar switching behavior and requires positive and negative values of delta B = BS1–BS2 for correct operation. For applications in which a magnet is mounted on the back side of the package (back-biased applications), the HAL 320 is recommended. The active offset compensation leads to constant magnetic characteristics over supply voltage and temperature. The sensor is designed for industrial and automotive applications and operates with supply voltages from 4.5 V to 24 V in the ambient temperature range from –40 °C up to 150 °C.
 

Features

Distance between Hall plates: 2.05 mm
Operates from 4.5 V to 24 V supply voltage
Switching offset compensation at 62 kHz
Overvoltage protection
Reverse-voltage protection at VDD-pin
Short-circuit protected open-drain output by thermal shutdown
Operates with magnetic fields from DC to 10 kHz
Output turns low with magnetic south pole on branded side of package and with a higher magnetic flux density in sensitive area S1 as in S2
On-chip temperature compensation circuitry minimizes shifts of the magnetic parameters over temperature and supply voltage range
The decrease of magnetic flux density caused by rising temperature in the sensor system is compensated by a built-in negative temperature coefficient of hysteresis
EMC corresponding to ISO 7637
 

Specifications

ABS
N
Brushless DC Motors
N
Configuration
3-Wire
Differential
H
Direction Detection
N
Ignition Timing
N
Magnetic B OFF
-3 mT
Magnetic B ON
3 mT
Multiple Magnets
Y
Package
SOT89
Position and End Detection
N
Rotating Speed
N
RPM Measurement
Y
Solid State Switch
N
Temp Range
-40 to 170 C
Window Lifter
N
 

Documents

Block Diagram
Datasheet
Product Selection Guide
RoHS Certification

Previously Viewed Products