Evaluation Board iC-MH

Manufacturer:
MFG Part #:

iC-MH EVAL MH1D

Part #:
IC-MHEVALMH1D
Availability:
Short Lead Time
RoHS Status:
Unit Price:$72.50
Qty:
Minumum Qty: 1

Ask a Question
Call Me
Email This Page
 
 

Product Information

The iC-MH 12-bit angular encoder is a position sensor with integrated Hall sensors for scanning a permanent magnet. The signal conditioning unit generates constant-amplitude sine and cosine voltages that can be used for angle calculation. The resolution can be programmed up to a maximum of 4,096 angular increments per rotation. The integrated serial interface also enables the position data to be read out to several networked sensors. And the integrated memory can be written embedded in the data protocol. The incremental interface with the pins A, B and Z supplies quadrature signals with an edge rate of up to 8 MHz. Interpolation can be carried out with maximum resolution at a speed of 120,000 rpm. The position of the index pulse Z is adjustable. The commutation interface with the signals U, V and Wprovides 120° phase-shifted signals for block commutation. The zero point of the commutation signals is freely definable in increments of 1.875° over 360°. The commutation signals are available for EC motors with 1 and 2 pole pairs. The RS422-compatible outputs of the incremental interface and the commutation interface are programmable in the output current and the slew rate. In conjunction with a rotating permanent magnet, the iC-MH module forms a one-chip encoder. The entire configuration can be stored in the internal parameter ROM with zapping diodes. The integrated programming algorithm assumes
 

Features

4x sensor arrangement for fault-tolerant adjustment
Amplitude control for optimum operating point
Extended temperature range from -40 to +125 C
Incremental output of sensor position up to 8 MHz edge rate
Integrated Hall sensors with automatic offset compensation
Integrated ZAP diodes for module setup and OEM data, programmable via serial interface
Interpolator with 4096 angular increments/resolution better than 0.1
Programmable resolution, hysteresis, edge spacing, zero position and rotating direction
Real-time system for rotation speed up to 120,000 rpm
RS422-compatible AB encoder signals with index Z
Serial interface for data output and configuration
Signal error (e.g. magnet loss) can also be read out via serial interface
SSI-compatible output mode
UVW commutation signals for EC motor applications
 

Previously Viewed Products

Evaluation Board iC-MH
Part #: iC-MH EVAL MH1D
Evaluation Board iC-MH