Light Chain Pulse Receiver

Manufacturer:
MFG Part #:

iC-NE SO8

Part #:
IC-NESO8
Availability:
Short Lead Time
RoHS Status:
Unit Price:$3.26
Qty:
Minumum Qty: 1

Ask a Question
Call Me
Email This Page
 
 

Product Information

The iC-NE device is a light chain receiver IC. Typical applications cover light curtains, light barriers and electro-sensitive protective equipment in general. Integrated on a single silicon chip the iC-NE contains a bandpass amplifier with a center frequency of typically 300 kHz, a differential current-signal output stage plus control logic to activate the amplifier and the output stage. In the deactivated state, the current consumption is very low and the current-signal outputs SN and SP are switched to high impedance (zero current). The logic consists of a three-stage shift register in which the first two stages are triggered by the rising edge of the clock input CLK. The third flipflop is triggerred with the falling clock edge, which produces an artificial delay in order to avoid race conditions when shifting the input data via the serial output to the next device in the chain. The bandpass amplifier is activated when DIN reads a logical ’1’. The output stage still remains disabled (zero current) until the output of the first flipflop changes to ’1’. This activates the bias for the complete signal path from light detection to the differential current-output stage. The differential outputs SP and SN are powered up to an equal current, as far as the attached photodiode does not receive any changes in light. The rising edge of a received light pulse (which produces an increase of photocurrent), causes the output current at SP to increase and at SN to decrease by an equal value. The sum of I(SP)+I(SN) is kept constant. For light curtain applications in which only one device is activated at a time, the outputs SN and SP can be attached to a two-wire bus. After processing the serial input data at DIN, the activated amplifier and output stage automatically return to standby mode, when the clock input receives the second rising edge. Therefore, a chain circuitry with multiple beams has to be set up with just a single data bit within a shift cycle. The IC contains protective diodes to prevent destruction by ESD. Logic input pins feature Schmitt trigger characteristics for high noise immunity. All pins are short-circuit proof.
 

Features

3-step shift register and control logic
Built-in bandpass filter with 300 kHz center frequency
Compatible to CMOS levels
Differential current-signal output with open drain low-side drivers
ESD protection
Fast flash recovery time of max. 30 s
Low standby current; circuit activation by input data
Nonlinear transfer function results in wide dynamic range of 100 nA to 1.5 mA for pulsed photocurrents
Option: extended temperature range of -20 to 85 C
Photoelectric amplifier adapted to standard photodiodes
Power-down reset
Recovery time below 10 s for excessive photocurrents of up to 1.8 mA
Single 5 V supply
Suited for high-risk applications according to IEC 61496-1
 

Documents

Ic-Haus Package Info

Previously Viewed Products

Light Chain Pulse Receiver
Part #: iC-NE SO8
Light Chain Pulse Receiver