The standard version of the WiFi-IT! EDK is specially designed to evaluate and develop wireless embedded sensor and control applications using the WiFi-IT! WL11 and WL10 modules.
The EDK can be configured to support all of the WiFi-IT! module features and operating environments. Standard .1 inch center connectors are provided for monitoring all interface signals, voltages and clocks. Each interface signal is connected to an LED monitor through the Logic Engine. The Logic Engine drives the LEDs according to the module output signal level and in the case of pulsed or clocked outputs, displays a blinking LED to indicate changing signal levels. In many cases, the Logic Engine can replace the need to monitor signals with an oscilloscope. It can also be used to give a quick confirmation that a WiFi-IT! module has been correctly programmed for a given task.
The EDK board can be used to develop OEM hardware that is directly controlled by a WiFi-IT! module or uses the module for wireless communication. The OEM designed device is connected through a reverse mating connector to a WiFi-IT! module on the EDK. When the OEM system is completely verified the OEM PCB and WiFi-IT! plug directly into each other!
The EDK Standard contains:
- Standard version of WiFi-Basic
- Full Integrated Development Environment
- Development Board with On-board LED Signal Monitoring
- Two WL11-IP WiFi-IT! modules
- One pre-configured Wi-Fi access point
- All cables and power connectors
- 3 months of support through the NPE 4-Hour Response Support Forum
