RS9113-N00-D1N n-Link Module Dual Band 2.4/5 Ghz with embedded Antenna

Manufacturer:
MFG Part #:

RS9113-N00-D1N

Part #:
RS9113-N00-D1N
Availability:
Short Lead Time
RoHS Status:
Unit Price:$28.60
Qty:
Minumum Qty: 1
Ask a Question
Call Me
Email This Page
 
 

Product Information

Back to top
The RS9113 n-Link™ module family is based on Redpine Signals' RS9113 ultra-low-power, single spatial stream, dual-band 802.11n. The RS9113 module integrates a multi-threaded MAC processor with integrated analog peripherals and support for digital peripherals, baseband digital signal processor, analog front-end, crystal oscillator, calibration OTP memory, dual-band RF transceiver, dual-band high-power amplifiers, baluns, diplexers, diversity switch and Quad-SPI Flash thus providing a fully-integrated solution for embedded wireless applications. The RS9113 based chips and modules leverage and improve upon Redpine's proven low power innovations from Lite-FTM products (RS9110) and provide WLAN 802.11n for integration into mobile and M2M communication devices. It can connect to a host processor through SDIO, USB, SPI or UART interfaces. 


Product Variants

Wi-Fi band of operation
  • Single band (2.4 GHz)
  • Dual band (2.4 GHz and 5 GHz)

Antenna
  • No embedded antenna
  • One embedded antenna and a u.FL connector for external antenna

Wireless configurations
  • Wi-Fi only
 

Features

Back to top
Ultra-low-power, low-cost and high-throughput 1 Tx 1 Rx Dual-band
802.11n
Supports 20MHz and 40MHz bandwidth
Data rates up to 150 Mbps using 1-Spatial Stream 802.11n
WLAN Tx output power up to +20dBm
WLAN Receiver with -97dBm Rx sensitivity
Integrated Ultra-low-power subsystem with <3uA watch-dog mode and <30uA standby mode.
Hardware Assisted Radar-detection for compliance to FCC and ETSI norms, enabling usage of more channels in the 5GHz band.
Complete software along with host driver for various operating systems such as Windows, Linux, Windows CE, and Android.
Single supply 3.0 to 3.6 V operation.
Support for multiple host interfaces to allow maximum flexibility for the system integrator. Host interfaces supported are USB 2.0, SDIO, SPI and UART
 

Documents

Back to top

Previously Viewed Products