Daughter Cards & OEM Boards Flash Emulation Daughter Board

Manufacturer:
MFG Part #:

C8051T600-EDB-K

Part #:
C8051T600-EDB-K
Availability:
Short Lead Time
RoHS Status:
Unit Price:$10.62
Qty:
Minumum Qty: 1
Ask a Question
Call Me
Email This Page
 
 

Product Information

Back to top
The C8051T60x Development Kit includes two daughter boards: an Emulation Daughter Board (EDB) and an SOIC Socket Daughter Board (SOIC-DB). The EDB has a C8051F300 device installed, which is a Flash-based device that can be used for the majority of C8051T60x code development. The SOIC-DB and the QFN-DB (available separately) are intended to allow both the programming of multiple C8051T60x devices, as well as system-level debugging of these devices. Once a C8051T60x device has been programmed, it cannot be erased, so it is advisable to use the C8051F300 for the majority of code development. Refer to Application Note “AN280: Differences Between the C8051F300 and the C8051T60x Device Family” for more details on how the C8051F300 can be used to develop code for the C8051T60x device family.

Symmetry Electronics is an authorized Silicon Labs distributor.
 

Features

Back to top
Analog Peripherals
- 10-Bit ADC (T600/602/604 only)
Up to 500 ksps
Up to 8 external inputs
VREF external pin, Internal Regulator or VDD
Internal or external start of conversion source
Built-in temperature sensor
- Comparator
Programmable hysteresis and response time
Configurable as interrupt or reset source
Low current
On-Chip Debug
- C8051F300 can be used as code development platform; complete development kit available
- On-chip debug circuitry facilitates full speed, non-intrusive in-system debug
- Provides breakpoints, single stepping, inspect/modify memory and registers
Supply Voltage 1.8 to 3.6 V
- On-chip LDO for internal core supply
- Built-in voltage supply monitor
Temperature Range: 40 to +85 C
Package Options:
- 3 x 3 mm QFN11
- 2 x 2 mm QFN10 (C8051T606 Only)
- MSOP10 (C8051T606 Only)
- SOIC14 (C8051T600/1/2/3/4/5 Only)
High-Speed 8051 C Core
- Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks
- Up to 25 MIPS throughput with 25 MHz clock
- Expanded interrupt handler
Memory
- 256 or 128 Bytes internal data RAM
- 8, 4, 2, or 1.5 kB byte-programmable EPROM code memory
Digital Peripherals
- Up to 8 Port I/O with high sink current capability
- Hardware enhanced UART and SMBus serial ports
- Three general purpose 16-bit counter/timers
- 16-bit programmable counter array (PCA) with three capture/compare modules
8 or 16-bit PWM
Rising / falling edge capture
Frequency output
Software timer
Clock Sources
- Internal oscillator: 24.5 MHz with 2% accuracy supports crystal-less UART operation
- External oscillator: RC, C, or CMOS Clock
- Can switch between clock sources on-the-fly; useful in power saving modes
 

Previously Viewed Products