Integrated DualAxisGyroscope High Performance 2 Axis with 0.5mm pkg thickness

MFG Part #:


Part #:
Short Lead Time
RoHS Status:
Unit Price:$4.15
Minumum Qty: 1
Ask a Question
Call Me
Email This Page

Product Information

Back to top
The ICG-1020S dual-axis MEMS angular rate sensor is designed for optical image stabilization (OIS) applications in smartphone camera modules and other mobile devices.

The ICG-1020S provides small 2.3x2.3mm2 package with 0.65mm thickness.

ICG-1020S supports up to 32 kHz ODR for backward compatibility to other Invensense dedicated OIS gyroscope products. This device provides extremely low RMS noise as well as noise density.

The high-resolution gyros support a programmable full-scale range of ±46.5 dps to ±374 degrees/sec, fast sample rate at up to 32 KHz, low phase delay including a fast 20 MHz SPI interface, very low rate noise at 4 mdps/√Hz, and extremely low power consumption at 2.5 mA. Precise sensitivity control allows a calibration-less strategy for gyroscope to save production cost and time by eliminating the shake table.

Symmetry Electronics is an authorized InvenSense distributor.


Back to top
ICG-1020S: Small 2.3 x 2.3 x 0.65 mm LGA Package
Very Low 4 mdps/vHz Rate Noise
Resistant to 36kHz to 40kHz ultrasonic wash frequencies
Drop-in replacement for IDG-2030U
Extremely tight sensitivity eliminates OIS dynamic calibration
DLPF with 40, 80, 160, 250 and 500 Hz settings
Programmable high-pass filters at 0.05 to 10 Hz to remove offset drift due to temperature & PCB warp
Independent ODR v. LPF selection for the most optimized performance
Narrow FSR Range from 46.5 dps to 374 dps
High Resolution at up to 700 LSB/(/s)
Fast Start Up Time; Sleep to Ready at 25 ms
SPI (3 & 4 Wire) Interface
Fast 20 MHz SPI Interface
Temperature sensor for offset temp compensation
Wide 1.71 V to 3.6 V Supply Voltage Range
Low 5 mW Active Power & 6A Sleep Mode
Self-test allows quick gyro functionally check
High 10,000g Shock Survivability


Back to top
InvenSense Product Brief