ICS-52000 Evaluation Board

MFG Part #:


Part #:
Lead Time 26 weeks
This item is currently not available for purchase online.

Please call us at 877-466-9722 to request a quote.
Ask a Question
Call Me
Email This Page

Product Information

Back to top
This is a simple evaluation board that allows quick evaluation of the performance of the ICS-52000 MEMS microphone. The small size and low profile of the flexible PCB enables direct placement of the microphone into a prototype or an existing design for an in situ evaluation. The board consists of an I²S-output microphone soldered to a flexible PCB. The only other component on the board is a 0.1μF supply bypass capacitor.

The flex PCB is designed to mate to a ZIF connector with 1.0 mm pin spacing. The Molex 52610-1071 connector is included in the kit with the flex PCB. The flex PCB can be mated to the connector by first pulling out the connector’s tan clamp, inserting the flex PCB, and then pushing the clamp closed. Wires can be soldered directly to this connector’s pins or it can be mounted directly on a rigid PCB for evaluation. It is recommended to use 28 AWG or smaller wire for soldering to this connector’s pins. The PCB thickness at the pin edge is 0.3 mm.

The only functional differences between the boards with the different microphones mounted are the functions of pins 5 and 9 on the connector. For the ICS-52000, pin 5 is the WS output and pin 9 should be set to VDD. All pin function descriptions are described in.

Symmetry Electronics is an authorized InvenSense distributor.

Previously Viewed Products

ICS-52000 Evaluation Board
Part #: EV_ICS-52000-ARRAY
ICS-52000 Evaluation Board