Runcore rSSD Solid State Drives

The rSSD series is designed optimally for a wide range of embedded applications. The supported densities range up to 8GB/16GB/32GB/64GB for different storage requirements.

With the pre-programmed firmware and unsurpassed reliability and performance, rSSD is the ultimate non-volatile storage solution that is easy to design and manufacture for today’s fast-moving consumer and industrial applications.

MLC(Multi-Level Cell) NAND Flash

---

SLC(Single Level Cell) NAND Flash

RunCore rSSD Key Features:

• Host Interface
  • Compatible with SATA 1.5Gb/s and 3.0Gb/s transfer rate(SATA Gen1 and Gen2)
  • Compliant with Serial ATA Revision 2.6 specification & Compliant with ATA-7 V3 specification
  • Supports partial/slumber power saving mode & Supports 48-bit Logical Block Addressing(LBA)
• Enhanced ECC
  • Advanced hardware BCH ECC engine : 8/15 bit per 512-byte and 16/30 bit per 1KB
• Advanced Global Wear Leveling
  • Fully utilizes each cell to even program/erase count across management units/die(s)
  • Maximizes product lifespan with minimal wear leveling and write amplification overhead
• Robust Data Protection
  • Static Data Refresh
  • Early weak block retirement option
  • Software/Hardware write protect option
  • Multiple data security zones
• Trim Command
  • Supports Trim Command
• Health Status Monitoring
  • Supports SMART commands to enable product life monitoring and user alert
• Upgradeable Firmware
  • Supports firmware in system programming(ISP) function for firmware upgrade
  • Provides customization(security features, hidden partition, special capacity, etc)
• NAND Flash
  • Uses MLC(Multi-Level Cell) NAND Flash
• Power Management
  • Power Supply : 3.3V
  • Prevents data corruption in case of sudden power-off
  • Automatic sleep and wake-up mechanism to save power
• Operating Temperature
  • Commercial : 0°C ~ 70°C & Industrial : -40°C ~ 85°C
• Form Factor
  • mSATA: 54mm*32mm
  • Half Slim : 54mm*42.5mm*5.73mm
  • 2.5 inch
  • RoHS compliant