HAL320SF-A Hall Switch Differential High Sensitivity SOT89

Manufacturer:
Family:
MFG Part #:

HAL320SF-A-4-R-1-00

Part #:
HAL320SF-A
Availability:
Short Lead Time
RoHS Status:
This item is currently not available for purchase online.

Please call us at 877-466-9722 to request a quote.

 
 

Product Information

Back to top
The HAL® 320 is a differential Hall switch produced in CMOS technology. The sensor includes two temperature-compensated Hall plates (2.25 mm apart) with active offset compensation, a differential amplifier with a Schmitt trigger, and an open-drain output transistor. The HAL 320 is a differential sensor which responds to spatial differences of the magnetic field. The Hall voltages at the two Hall plates, S1 and S2, are amplified with a differential amplifier. The differential signal is compared with the actual switching level of the internal Schmitt trigger. Accordingly, the output transistor is switched on or off. The sensor has a bipolar switching behavior and requires positive and negative values of ΔB = BS1 - BS2 for correct operation. 
 
The sensor is designed for industrial and automotive applications and operates with supply voltages from 4.5 V to 24 V in the ambient temperature range from –40 °C up to 150 °C. The HAL 320 is an ideal sensor for target wheel applications, ignition timing, anti-lock brake systems, and revolution counting in extreme automotive and industrial environments
 

Features

Back to top
Distance between Hall plates: 2.25 mm
Operates from 4.5 V to 24 V supply voltage
Switching offset compensation at 62 kHz
Overvoltage protection
Reverse-voltage protection at VDD-pin
Short-circuit protected open-drain output by thermal shutdown
Operates with magnetic fields from DC to 10 kHz
Output turns low with magnetic south pole on branded side of package and with a higher magnetic flux density in sensitive area S1 as in S2
On-chip temperature compensation circuitry minimizes shifts of the magnetic parameters over temperature and supply voltage range
The decrease of magnetic flux density caused by rising temperature in the sensor system is compensated by a built-in negative temperature coefficient of hysteresis
EMC corresponding to ISO 7637
 

Specifications

Back to top
ABS
N
Brushless DC Motors
N
Configuration
3-Wire
Differential
H
Direction Detection
N
Ignition Timing
Y
Magnetic B OFF
-3.5 mT
Magnetic B ON
3.5 mT
Multiple Magnets
N
Package
SOT89
Position and End Detection
N
Rotating Speed
N
RPM Measurement
Y
Solid State Switch
N
Temp Range
-40 to 170 C
Window Lifter
N
 

Documents

Back to top
 

Previously Viewed Products